SF 10-40
- Torque:
- Contact Force:
- 400 kN
Depending on contact pressure, coefficient of friction and brake disc diameter
The high capacity of the SF-series makes them particularly suitable as secondary emergency brakes on hoist gears and on downhill conveyors. Further applications are possible in material handling, requiring power and compact design in either direction of rotation, particularly in replacing band brakes.
- Two identical caliper halves, ready for operation, with spring packs set to nominal force and limit switch release control
- Up to 2 mm air gap between brake pad and disc
- Easy, manual pad wear compensation
- Sintered linings
- Proximity switch pad wear, brake release, brake set
- Complete piped supports for one or more calipers
- Hydraulic power units or BUEL G®
- Special seals for flameproof fluids
- Cleaning pads
- Brake discs
- Monitoring system CMB
- Piping set steel / stainless steel
Additional PRODUCTS
- All
- Caliper / Disc Brakes
- Components & Accessories
- Couplings
- Drum & Band Brakes
- Hydraulic Systems
- Locking Devices
- Monitoring & Control Systems
- Motor Mounted Brakes
- Pneumatic Drum Clutches & Brakes
- Stop Turn Lock Systems
- Storm Brakes (Rail & Wheel Brakes)
- Thruster / BUEL®
- Wind Turbine Components
- WPT Disc Clutches & Brakes
Gas-hydraulic buffers are installed as impact energy absorber on crane gantries, trolleys, elevators, stackers, reclaimers and other industrial equipment.
Protective element to be connected parallel to the output of the rectifiers BGL, EGL and SGL to increase the interurruption capacity
Din rail mounted unit switches from bridge rectification to half-wave rectification
WPT Low Inertia Brakes are suited for high cycle applications or general brake duties. These heavy duty brakes afford increased precision for your processes with minimal part movement during start and stop, acceleration time is decreased leading to more cycles per minute.
WPT Low Inertia Clutches and Brakes are suited for high cycle applications or general clutch/brake duties.
WPT Low Inertia High Torque Clutches are suited for high cycle applications or general clutch duties.
This flywheel PTO is designed for inline and sideload applications on all internal combustion engines with standard SAE industrial flywheel or flywheel housing dimensions.
WPT Power has engineered the WPT Pilotless™ Mechanical Power Take-off to eliminates the pilot bearing and increases side load capacity over previous generations of PTO products.
WPT Planetary Hydraulic Hoists are ideal for applications in the oil & gas, utility, and crane industries. WPT’s hoist designs adhere to SAE J706 standards and provide lifting capacities of 8,000 lbf and 12,000 lbf, respectively.
WPT Planetary Hydraulic Winches provide fast line speed and consistent, powerful pull capacity.
WPT® Power Grip clutches are designed to accommodate in-line and shaft-to-shaft power transmission applications with large inertia loads.
The WPT® Power Grip PO Clutch is suitable for in-line and shaft-to-shaft power transmission applications.
The WPT® Type 2 Hydraulic Power Take-Off utilizes large spherical roller bearings designed for heavier duty sideload capacity.
WPT® water cooled brakes (WCBs) are high energy absorbing solutions used as dynamic tensioning and static holding brakes.
WPT Worm Gear Winches are offered from 9,000 lbf to 20,000 lbf, with options of hydraulic or electric operation.